Caps

A0097 Fill Cap

Click here to view this product in our catalog

The Emco Wheaton A0097-005 series Top Seal Fill Cap is designed for use on conventional A0030 or coaxial A0089 and A0096 Adapters. The cap is lockable and features a self-aligning, toggle-action design with center collar to prevent breakage; made of corrosion resistant aluminum

Material
Body: Aluminum
Cams: Brass
Links: Steel
Seal: Buna-N

 

  • CARB E.O. G-70-97-A
    Approved under Phase I EVR
    Executive Order VR-105
    Complies with EPA 40 CFR Part 63

A0097-004LP Low Profile Fill Cap

View In Catalog

View Product Cutsheet

The A0097-004LP Low Profile Fill Cap is designed for use when there is limited space between the top of the adapter and the spill containment lid. The cap is painted gray.

Material
Body: Aluminum
Lever: Ductile Iron
Gasket: Buna-N

  • Approved under Phase I EVR
    Executive Order VR-105

A0097-010 Tank Gauge Cap

Click here to view this product in our catalog

The A0097-010 Tank Gauge Cap has the same features of the A0097-005 Fill Cap and is designed with a grommet to allow a cable to pass through the cap. The A0097-010 comes with two sizes of leak tight connector nut fittings: .125”-.375” and .190”-.250”.

Material
Body: Aluminum
Cams: Brass
Links: Steel
Seal: Buna-N

  • Approved under Phase I EVR
    Executive Order VR-105

 

A0099 Vapor Adapter Cap

Click here to view this product in our catalog

The Emco Wheaton A0099-002/003 Vapor Adapter Cap features a cam system designed for Stage I vapor recovery dual point systems. The cap is lockable and features a self-aligning, toggle-action design with center collar to prevent breakage. The A0099 is made of corrosion resistant aluminum, powdered coated orange for vapor line identification.

Material
Body: Aluminum
Cams: Brass
Links: Steel
Seal: Buna-N

  • CARB E.O. G-70-97-A
    Approved under Phase I EVR
    Executive Order VR-105
    Complies with EPA 40 CFR Part 63

A0099-001TEST Vapor Test Cap

Click here to view this product in our catalog

The A0099-001TEST Vapor Test Cap is used when performing a pressure decay test. The cap incorporates the same features as the A0099-002 Vapor Cap. The extended tube underneath the cap opens the poppet on the vapor adapter. Pressure is injected through the Schrader valve, and a gauge can be connected to the barbed fitting.

A0099-004LP Low Profile Vapor Adapter Cap

View In Catalog

View Product Cutsheet

The A0099-004LP Low Profile Cap is designed for use when there is limited space between the top of the adapter and the spill containment lid. The cap is painted orange for vapor line identification.

Material
Body: Aluminum
Lever: Ductile Iron
Gasket: Buna-N